Dodge Nitro: To open and close the hood
To open the hood, there are two latches that must be released. 1. Pull the hood release lever located under the left side of the instrument panel.
Hood Release Lever
2. Push the safety latch lever to the right. It is located between the grille and hood opening left of the center.
Safety Latch
CAUTION:
To prevent possible damage:
• Do not slam the hood to close it.
• Lower the hood to approximately 6 in (15.2 cm)
above the closed position and drop the hood to
latch it.
• Never drive your vehicle unless the hood is fully
closed, with both latches engaged.
NOTE: Ensure hood prop rod is fully seated into clip before closing hood to prevent damage to grille.
WARNING: Be sure the hood is fully latched before driving your vehicle. If the hood is not fully latched, it could open when the vehicle is in motion and block your vision. Failure to follow this warning could result in serious injury or death.
Seats
Seats are a primary part of the Occupant Restraint System of the vehicle. They need to be used properly for safe operation of the vehicle. WARNING: • Do not allow people to ride in any area o ...Lights
Multifunction Lever The multifunction lever controls the operation of the parking lights, headlights, headlight beam selection, passing light, fog lights, instrument panel light dimming and tur ...See also:
Compass Messages
CAL
This message is displayed when the compass needs to be calibrated. See Compass
on page 5‑5.
– – –
Three dashes will be displayed if the compass needs service. See your dealer
fo ...
Warning signals
The Intelligent Key system is equipped with a
function that is designed to minimize improper
operations and to help prevent the vehicle from
being stolen. The warning buzzer sounds and
the war ...
Resetting
If the battery has been disconnected, the auto
open function must be reset so that it will work
properly.
1. Gently raise the front section of the button
to close the window and hold it for one ...