Jeep Liberty: To Deactivate - Electronic Speed Control — If Equipped - Understanding The Features Of Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: To Deactivate

A soft tap on the brake pedal, pushing the CANCEL button, or normal brake pressure while slowing the vehicle will deactivate Electronic Speed Control without erasing the set speed memory. Pressing the ON/OFF button or turning the ignition switch OFF erases the set speed memory.

    To Set A Desired Speed
    Turn the Electronic Speed Control ON. When the vehicle has reached the desired speed, press the SET (-) button and release. Release the accelerator and the vehicle will operate at the selected s ...

    To Resume Speed
    To resume a previously set speed, push the RES (+) button and release. Resume can be used at any speed above 20 mph (32 km/h). ...

    See also:

    Heating
    Heating To direct warm air toward the floor: 1. Set the air inlet selection button to the OFF position. 2. Set the airflow control dial to the “” position. 3. Set the temperature cont ...

    Elapsed Time
    Shows the total elapsed time of travel since the last reset. Elapsed time will increment when the ignition switch is in the RUN or START position. Elapsed time is displayed as follows: hours:min ...

    Towing Your Vehicle Behind a Motorhome
    Your vehicle can be towed behind a motorhome at legal highway speeds up to 65 mph (100 km/h). Do not exceed 65 mph (100 km/h). Otherwise, severe transmission damage will occur. To avoid damag ...