Range Rover Evoque: Suspending and resuming cruise control
Suspend cruise control with a single press of
control (3).
To resume cruise control at the previous set
speed, press control (2).
RES (2) should be used only
if the
driver is aware of the set speed and
intends to return to it.
It is not recommended to resume set
speed when a low gear is selected as
excessive engine speeds will occur.
READ NEXT:
Cruise control will switch off but the set speed
will remain in the memory when:
- The CAN button (3) is pressed.
- The brake pedal is pressed.
- Speed falls below 30km/h (18mph).
- Neutral, Park
Diesel only
When enabled, a CO2 emission indicator is
displayed in the message centre. The higher
the numeric reading, the more CO2 is being
emitted and the more fuel is being used. See
56, VEH
SEE MORE:
The system is operated using the remote
control.
To release the remote from the docked
position, press at the top of the remote (1) to
unlatch it.
Do not attempt to pull the
remote
control out of its docked position.
Using the appropriate button (6) or (10) or on
screen soft key (right
The driver
and front seat passenger
must not ride with the seat fully
reclined.
Do not adjust
the seat while the
vehicle is moving.
The seat, head restraint, seat belt and airbags,
all contribute to the protection of the user.
Correct use of these components will give you
greater prote
© 2011-2024 Copyright www.rrevoque.org