Jeep Liberty: To Arm The System
1. Remove the key from the ignition switch and exit the vehicle.
2. Lock the doors and liftgate by pressing the power door LOCK switch or the LOCK button on the Remote Keyless Entry (RKE) transmitter.
NOTE: The Vehicle Security Alarm will not arm if you lock the doors with the manual door lock plungers or the driver’s door lock cylinder.
3. Close all doors. The Vehicle Security Light in the instrument cluster will flash rapidly for about 16 seconds to signal that the Vehicle Security Alarm is arming.
During this period, opening any door or the liftgate will cancel the arming process. If the Vehicle Security Alarm is set successfully, the Vehicle Security Light will flash at a slower rate to indicate the alarm is armed.
NOTE: For added security, whenever the Security Alarm is armed, the HomeLink /Garage Door Opener (if equipped) is disabled as well.
Rearming Of The System
If something triggers the Vehicle Security Alarm, and no
action is taken to disarm it, the Vehicle Security Alarm
will turn off the horn after three minutes, turn off all of
the visual signals a ...
To Disarm The System
Either press the UNLOCK button on the RKE transmitter
or insert a valid Sentry Key into the ignition lock
cylinder and turn the key to the ON/RUN position.
NOTE:
• Unlocking the doors with th ...
See also:
Securing the vehicle to prevent it from rolling away
WARNING
Only jack up the vehicle on level ground or on slight inclines/declines. The
vehicle could otherwise fall off the jack and injure you or others.
If your vehicle is equipped with a whe ...
Automatic Transmission Fluid
Specified Fluid
Use an automatic transmission fluid SUZUKI ATF 3317 or Mobil ATF 3309.
Fluid Level Check
CAUTION: Driving with too much or too little fluid can damage the transmission.
You must ch ...
Average speed
The system calculates the average speed from
the last resetting. Reset using RESET. ...
