Subaru Forester: START
The engine is started in this position. The starter cranks the engine to start it. When the key is released (after the engine has started), the key automatically returns to the “ON” position.
Do not turn the ignition switch to the “START” position while the engine is running.
If your registered key fails to start the engine, pull out the key once (the security indicator light will blink), and then insert the key in the ignition switch and turn it to the “START” position and again try to start the engine.
NOTE
The engine may not start in the following
cases:
- The key grip is touching another key or a metallic key holder.
- The key is near another key that contains an immobilizer transponder.
- The key is near or touching another transmitter.
ON
This is the normal operating position after
the engine is started. ...
Key reminder chime
The reminder chime sounds when the
driver’s door is opened and the ignition
switch is in the “LOCK” or “Acc” position.
The chime stops under the following
conditions.
- when the igni ...
See also:
ESN/SID Access
With the ignition switch in the ON/RUN or ACC position
and the radio on, press the SETUP button and scroll
using the TUNE/SCROLL control knob until Sirius ID is
selected. Press the TUNE/SCROLL c ...
ISOFIX/LATCH lower anchors
Using the ISOFIX/LATCH lower child seat anchors
Lower anchors for ISOFIX/LATCH-equipped
child seats are located in the rear, outboard
seats, hidden below the backrest cushions.
Symbols on the ...
General warning/information message (amber)
General warning/information message (amber)
Illuminates when a non-critical
warning message or an
information message is available in
the message centre. ...
