Jeep Liberty: Reset
It may be necessary at some point in time to reactivate the Auto Up feature. To do so, perform the following procedure:
1. Pull the window switch up to close the window completely and continue to hold the switch up for an additional two seconds after the window is closed.
2. Push the window switch down firmly to the second detent to open the window completely and continue to hold the switch down for an additional two seconds after the window is fully open.
Auto Up Feature With Anti-Pinch Protection — If Equipped
On some models, the driver’s and front passenger’s (if equipped for passenger side) power window switches have an “Auto Up” feature. Pull the window switch fully upward to the second det ...Window Lockout Button
The window lockout button on the driver’s door trim panel allows you to disable the window control on the rear doors. To disable the window control on the other doors, press and release the wi ...See also:
Loading tips
- The GVW must not exceed GVWR or
GAWR as specified on the F.M.V.S.S./
C.M.V.S.S. certification label.
- Do not load the front and rear axle to
the GAWR. Doing so will exceed the
GVWR.
- ...
Single locking
Single locking secures the vehicle and prevents
the doors from being opened from outside. The
doors may still be unlocked and opened using
the interior door locks and release levers. In
this state ...
Trailer towing
In this section you will find safety tips and information
on limits to the type of towing you can reasonably do
with your vehicle. Before towing a trailer, carefully
review this information to t ...