Range Rover Evoque: Replacement sensor
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Tyre pressure monitoring system / Replacement sensor
Should the sensor require replacing, it should be carried out by a Dealer/Authorised Repairer.
A replacement sensor must be fitted to a running wheel in order to be recognised by the system. The vehicle needs to be stationary for 15 minutes during the sensor fitment before the system is ready to detect the new sensor.
The vehicle must be driven for a minimum of fifteen minutes after the sensor change, and then remain stationary for fifteen minutes to activate full TPM system operation.
If the TPM system warning for any wheel does not clear, even after ensuring correct inflation and driving for more than ten minutes above 25 km/h (18 mph), you should seek qualified assistance as soon as possible.
READ NEXT:
Tyre repair kit
If you are in any doubt
regarding your
ability to carry out the instructions,
contact your Dealer/Approved
Repairer before attempting the repair.
Your vehicle may not be equipped with a spare
Safety information
Some tyre damage may only be
partially sealed, or may not seal at
all, depending on the amount and type
of damage. Any loss of tyre pressure
can seriously affect vehicle safety.
Do not use the t
SEE MORE:
Telephone safety
Switch off your telephone in
areas
with a high explosion risk. This
includes filling stations, fuel storage
areas or chemical factories, as well
as places where the air contains fuel
vapour, chemicals or metal dust.
Always stow your mobile phone
securely.
The functioning of cardiac
pacem
Headlamps
Principle of Operation
Three types of headlamp are available: Halogen, bi-xenon or Adaptive Front
Lighting System (AFS).
For a detailed description of the headlamps operation, refer to the relevant
Description and Operation section of the
workshop manual. REFER to: (417-01 Exterior Lighting)
Give
© 2011-2024 Copyright www.rrevoque.org
