Subaru Forester: Registering (pairing) device
1. Select the “PAIR AUDIO” (type C audio)/“Pair Audio Player” (type D audio) menu. If a device is already registered, “MEMORY FULL” is displayed and the mode changes to the Bluetooth® audio setting mode.
2. After the passkey is shown on the display, input the passkey into the cell phone. If you input the correct passkey, “PAIRED” is displayed and the registering procedure is finished. If you input an incorrect passkey, “FAILED” is displayed, the registering procedure was not successful and the mode changes to the Bluetooth® audio setting mode.
NOTE
After the ignition switch is turned to the
“LOCK” position, the registered device
is not automatically connected to the
system even if the ignition switch is
turned to the “Acc” or “ON” position.
Setting Bluetooth® audio
1. Select “BT-A SETUP” by pressing the
“MENU” button (type C audio)/Select “BT
Audio Setup” by operating the “TUNE/
TRACK/CH” dial (type D audio).
2. Perform the following proce ...
Selecting device
1. Select the “SELECT AUDIO” (type C
audio)/“Select Audio Player” (type D
audio) menu. If no devices are registered,
“EMPTY” is displayed and the mode
changes to the Bluetooth® au ...
See also:
ABS (Anti-lock Brake System)
The ABS system prevents the lock-up of
wheels which may occur during sudden
braking or braking on slippery road surfaces.
This helps prevent the loss of
steering control and directional stabili ...
Disarming the System
To disarm the system, do one of the following:
○ Press on the RKE transmitter.
○ Turn the ignition to ON/RUN.
○ Allow the alarm to time out after about 30 seconds and reset itsel ...
Emission control system
WARNING: Do not park, idle, or drive your vehicle in dry grass
or other dry ground cover. The emission system heats up the
engine compartment and exhaust system, which can start a fire.
WARNING: ...
