Subaru Forester: Reclining the seatback (if equipped)
To prevent the passenger from sliding under the seatbelt in the event of a collision, always put the seatback in the upright position while the vehicle is in motion. Also, do not place objects such as cushions between the passenger and the seatback. If you do so, the risk of sliding under the lap belt and of the lap belt sliding up over the abdomen will increase, and both can result in serious internal injury or death.
If the vehicle is equipped with a cargo area cover, observe the following precautions.
- Be careful not to pinch your hand between the headrest and the cargo area cover when you recline the rear seat.
- Move the front cover of the cargo area cover backward so that the cover is not damaged by the reclined seatback. Refer to “Cargo area cover (dealer option)”.
Push the switch and adjust the seatback to the desired position.
Then release the switch and make sure the seatback is securely locked into place.
Rear center seating position
The head restraint is not intended to be used at the lowest position. Before sitting on the seat, raise the head restraint to an appropriate position depending on your sitting height. ...Folding down the rear seatback
- When you fold down the seatback, confirm that there are no passengers or objects on the rear seat. Not doing so creates a risk of injury or property damage if the seatback suddenly f ...See also:
Towing With HSA
HSA will provide assistance during acceleration on an
incline while towing a trailer.
WARNING!
• If you use a trailer brake controller with your
trailer, the trailer brakes may be activated a ...
Electronic Range Select (ERS) Mode
ERS or manual mode allows for the selection of the range of gear positions. Use
this mode when driving down hill or towing a trailer to limit the top gear and vehicle
speed.
To use this feature:
...
Tire ratings
Speed ratings
The speed ratings in the table translate as follow:
Load ratings
See page 292 for an explanation of the load
rating on the sidewall of the tire. ...