Jeep Liberty: Rear Window Wiper/Washer
The rear wiper/washer is controlled by a rotary switch located on the control lever. The control lever is located on the right side of the steering column.
Rear Wiper/Washer Control
Rotate the switch upward to the first detent position for rear wiper operation.
NOTE: The rear wiper operates in an intermittent mode only.
Rotate the switch upward past the first detent to activate the rear washer. The washer pump will continue to operate as long as the switch is held (for a maximum of 10 seconds). Upon release, the wiper will cycle two times before returning to the set position.
If the rear wiper is operating when the ignition is turned OFF, the wiper will automatically return to the “park” position. When the vehicle is restarted, the wiper will resume function at whichever position the switch is set.
NOTE: The rear wiper and the rear washer will not operate If the liftgate flipper glass is open.
Rear Window Defroster
The rear window defroster button is located on the
climate control (Mode) knob. Press this button to
turn on the rear window defroster and the heated outside
mirrors. An indicator in the butto ...
See also:
Instruments and Controls
This section gives information about
the controls and displays that
contribute to the daily operation of
your vehicle. All the essential
controls are within easy reach.
Control Locations
...
Side airbags
These are designed to protect the thorax region
of the torso and will deploy only in the event of
a side impact and then, only on the side of the
impact. ...
Specifications
The specifications given here are for general information only. Please check
with an authorized Kia dealer for more precise and more up-to-date information.
...
