Mercedes-Benz GLK-Class: Cornering light function - Exterior lighting - Lights and windshield wipers - Mercedes-Benz GLK-Class Owner's ManualMercedes-Benz GLK-Class: Cornering light function

The cornering light function improves the illumination of the road over a wide

The cornering light function improves the illumination of the road over a wide angle in the direction you are turning, enabling better visibility in tight bends, for example. It can only be activated when the low-beam headlamps are switched on.

Active: if you are driving at speeds below 25 mph (40 km/h) and switch on the turn signals or turn the steering wheel.

Not active: if you are driving at speeds above 25 mph (40 km/h) or switch off the turn signal or turn the steering wheel to the straight-ahead position.

The cornering light function may remain lit for a short time, but is automatically switched off after no more than three minutes.

    Active light function
    The active light function is a system that moves the headlamps according to the steering movements of the front wheels. In this way, relevant areas remain illuminated while driving. This allows ...

    Headlamps fogged up on the inside
    The headlamps may fog up on the inside if there is high atmospheric humidity. Drive with the headlamps switched on. The level of moisture diminishes, depending on the length of the journey and ...

    See also:

    N (Neutral)
    This position is for restarting a stalled engine. In this position the wheels and transmission are not locked. In this position, the transmission is neutral; the vehicle will roll freely, eve ...

    To select a track from its beginning
    Turn the “TUNE/TRACK/CH” dial clockwise to skip to the beginning of the next track/file. Each time the dial is turned, the indicated track/file number will increase. Turn the “TUNE/TRAC ...

    How to use the rear view camera
    When the shift lever or select lever is set to “R”, the rear view camera automatically displays the rear view image from the vehicle. When the lever is set to other positions, the image be ...