Subaru Forester: Rear gate – if the rear gate cannot be opened - In case of emergency - Subaru Forester Owner's ManualSubaru Forester: Rear gate – if the rear gate cannot be opened

In the event that you cannot open the rear gate by operating the power door locking switches or the remote keyless entry system, you can open it from inside the cargo area.

1. Remove the access cover at the

1. Remove the access cover at the bottom-center of the rear gate trim.

2. Locate the rear gate lock release lever behind the rear gate trim panel.

Never operate the rear gate lock

Never operate the rear gate lock release lever with fingers because doing so may cause an injury. Always use a screwdriver or a similar tool.

3. Turn the lever to the right position

3. Turn the lever to the right position using a screwdriver.

4. Open the rear gate from outside by holding the rear gate with your hands.

    Towing with all wheels on the ground
    1. Release the parking brake and put the transmission in neutral. 2. The ignition switch should be in the “Acc” position while the vehicle is being towed. 3. Take up slack in the towline ...

    Moonroof – if the moonroof cannot be closed
    If the moonroof cannot be closed with the moonroof switch, you can close the moonroof manually. 1. Remove the plug on the roof trim of the cargo area by inserting the end of the flathead sc ...

    See also:

    Anti-Pinch Feature
    If an object is in the path of the sunroof when it is closing, the anti-pinch feature detects the object and stops the sunroof from closing at the point of the obstruction. The sunroof then return ...

    Automatic powerfold mirrors
    Powerfold mirrors can be configured to automatically fold when the vehicle is locked and unfold when unlocked. This function can be enabled/disabled by your Dealer/Authorised Repairer. Note: If ...

    Example: step 1 to 3
    The following table shows examples on how to calculate total and cargo load capacities with varying seating configurations and number and size of occupants. The following examples use a load limit ...