GMC Terrain: Passenger Compartment Air Filter
The filter removes dust, pollen, and other airborne irritants from outside air that is pulled into the vehicle.
The filter should be replaced as part of routine scheduled maintenance. See Maintenance Schedule on page 11‑3 for replacement intervals. To find out what type of filter to use, see Maintenance Replacement Parts on page 11‑14.
The passenger compartment air filter can be accessed by removing the entire glove box.
1. Open the glove box completely and locate the stop tab on top of the glove box door.
2. Push the stop tab upwards until the stop tab is under the instrument panel
assembly and the glove box is released.
3. Unsnap the tabs beneath the glove box that connects it to the bottom of the instrument
panel assembly.
4. Remove the glove box.
5. Locate the service door for the passenger compartment air filter.
6. Push the two tabs upwards and release the latches holding the service door. Lift
the service door.
7. Remove the old air filter.
8. Install the new air filter.
9. Close the service door and latches.
10. Re-install the glove box.
See your dealer if additional assistance is needed.
Air Vents
Use the air outlets, located in the center and on the side of the instrument panel, to direct the airflow. Use the thumbwheels located near the center air outlets, to open or close off the airflow ...See also:
Attention (in French)
ATTENTION
■Précautions à observer avec les sacs de sécurité gonflables SRS
Respectez les précautions suivantes avec les sacs de sécurité gonfla ...
Instrument Cluster Descriptions
1. Fuel Gauge
The fuel gauge shows level of fuel in tank when ignition
switch is in the ON/RUN position.
2. Fuel Door Reminder
This symbol indicates the side of the vehicle
where the fuel cap ...
Vehicles with automatic transmission
Apply the parking brake firmly.
Shift the transmission to position P.
Using the SmartKey
Turn the SmartKey to position 0 in the ignition lock and remove it. The
immobilizer is activated ...