Ford Escape: Parking brake
Apply the parking brake whenever the vehicle is parked. To set the parking brake, press the parking brake pedal down until the pedal stops.
The BRAKE warning lamp in the instrument cluster illuminates and remains illuminated (when the ignition is turned on) until the parking brake is released.
WARNING: If the parking brake is fully released, but the brake warning lamp remains illuminated, the brakes may not be working properly. See your authorized dealer.
WARNING: Always set the parking brake fully and make sure that the gearshift is securely latched in P (Park) (automatic transmission) or in 1 (First) (manual transmission).
The parking brake is not recommended to stop a moving vehicle.
However, if the normal brakes fail, the parking brake can be used to stop your vehicle in an emergency. Since the parking brake applies only the rear brakes, the vehicle’s stopping distance will increase greatly and the handling of your vehicle will be adversely affected.
Pull the release lever to release the brake. Driving with the parking brake on will cause the brakes to wear out quickly and reduce fuel economy.
Brake over accelerator
This vehicle is equipped with a brake over accelerator feature. In the event the accelerator pedal becomes stuck or entrapped, applying steady and firm pressure to the brake pedal will both slow the ...AdvanceTrac with Roll Stability Controlâ„¢ (RSC Stability Enhancement System
The AdvanceTrac with RSC system provides the following stability enhancement features for certain driving situations: • Traction control (TCS), which functions to help avoid drive-wheel spin an ...See also:
Displaying navigation instructions
In the Navi menu, the multifunction display shows navigation instructions. For
more information, see the separate operating instructions.
Switch on COMAND (see the separate operating instruction ...
Pulling a Trailer
Here are some important points:
○ There are many laws, including speed limit restrictions that apply to trailering.
Check for legal requirements with state or provincial police.
○ Do n ...
Reprogramming a single HomeLink® button
To reprogram a HomeLink® Universal Transceiver
button, complete the following.
1. Push and hold the desired HomeLink®
button. Do not release the button until step
4 has been completed.
2. Wh ...