Hyundai Tucson: Parking brake
Applying the parking brake
To engage the parking brake, first apply the foot brake and then without pressing the release button in, pull the parking brake lever up as far as possible. In addition it is recommended that when parking the vehicle on a gradient, the shift lever should be positioned in the appropriate low gear on manual transaxle vehicles or in the P (Park) position on automatic transaxle vehicles.
CAUTION: Driving with the parking brake applied will cause excessive brake pad (or lining) and brake rotor wear.
Releasing the parking brake
To release the parking brake, first apply the foot brake and pull the parking brake lever slightly. Secondly, depress the release button and lower the parking brake lever while holding the button.
Day/night inside rearview mirror
Manual Type Your Hyundai is equipped with a day/night inside rearview mirror. The "night" position is selected by flipping the tab at the bottom of the mirror toward you. In the &q ...Tail gate
o Pull and raise the "DOOR" release lever to open the tail gate. o To close, lower the door, then press down on it until it locks. To be sure the door is securely fastened, try to ...See also:
Steering
...
Safety Labels
These labels are in the locations
shown. They warn you of potential
hazards that could cause serious
injury or death. Read these labels
carefully.
If a label comes off or becomes hard
to re ...
Tools and jack
Storage
The tools and jack are stowed on the right side of the luggage area. The storage
location of the tools and jack should be remembered in case of an emergency.
1- Jack. 2- Tools.
Tools
...