Subaru Forester: Maximum allowable speeds - Shifting speeds - Manual transmission - Starting and operating - Subaru Forester Owner's ManualSubaru Forester: Maximum allowable speeds

The following tables show the maximum speeds that are possible with each different gear.

Never exceed the speed limit listed in the following table for each gear position except for brief acceleration in an emergency.

The tachometer’s needle will enter the red area if these speeds are exceeded.

Failure to observe this precaution can lead to excessive engine wear and poor fuel economy.

Never exceed the posted speed limit.

Never exceed the posted speed limit.

When shifting down a gear, ensure

When shifting down a gear, ensure that the vehicle is not travelling at a speed exceeding the Maximum Allowable Speed for the gear which is about to be selected. Failure to observe this precaution can lead to engine over-revving and this in turn can result in engine damage.

In addition, sudden application of engine brakes when the vehicle is travelling on a slippery surface can lead to wheel locking; as a consequence, control of the vehicle may be lost and the risk of an accident increased.

    Recommended shifting speeds
    The best compromise between fuel economy and vehicle performance during normal driving is ensured by shifting up at the speeds listed in the following table. ...

    Driving tips
    Do not drive with your foot resting on the clutch pedal and do not use the clutch to hold your vehicle at a standstill on an upgrade. Either of those actions may cause clutch damage. Do not d ...

    See also:

    Filling a Portable Fuel Container
    WARNING Never fill a portable fuel container while it is in the vehicle. Static electricity discharge from the container can ignite the fuel vapor. You can be badly burned and the vehicle damaged ...

    Blind spot monitor
    The Blind Spot Monitor (BSM) system is a supplement to, not a replacement for, a safe driving style and use of the exterior and rear-view mirrors. Please note that BSM may not be able to give ...

    Ignition mode II
    - With the remote key fully pressed into the ignition slot, press START/STOP ENGINE for approximately 2 seconds. ...