Volvo XC60: Manually folding down the rear seat's outboard head restraints - Rear seats - Seats - Your driving environment - Volvo XC60 Owner's ManualVolvo XC60: Manually folding down the rear seat's outboard head restraints

Manually folding down the rear seat's outboard head restraints
Manually folding down the rear seat's outboard head restraints

• Pull the handle closest to the head restraint to fold it down.

• To return the head restraint to the upright position, push it up until it clicks into place.

NOTE
• The head restraint must be returned to the upright position manually.
• The outboard head restraints cannot be folded down on models that are not equipped with this button.

CAUTION The rear head restraints should not be kept folded down for prolonged periods. This could result in pressure marks in leather upholstery.

WARNING
For safety reasons, no one should be allowed to sit in the outboard rear seat positions if the head restraints are folded down.
If these positions are occupied, the head restraints should be in the upright (fixed) position.

    Rear center head restraint
    Rear center head restraint The center head restraint should be adjusted according to the passenger's height. The restraint should be carefully adjusted to support the occupant's head. • Pu ...

    Automatically folding down the rear seat’s outboard head restraints
    Automatically folding down the rear seat’s outboard head restraints 1. The ignition must be in mode I or II. 2. Press the button to lower the rear head restraints for improved visibility. NOT ...

    See also:

    Removing a wheel
    Unscrew the wheel bolts. Do not place wheel bolts in sand or on a dirty surface. The bolt and wheel hub threads could otherwise be damaged when you screw them in. Remove the wheel. ...

    Rds-tmc display
    When a TMC signal is received the icon in the top left of the screen will appear green. If a TMC signal is not being received, the icon will be shown with a bar through it. The system will inform ...

    Setting automatic connection of the device on or off
    If “BT Power” is set to on, the registered device will be connected automatically when the engine switch is turned to the “ACC” position. 1 Select “BT Power” using . 2 Select “ON” o ...