Ford Escape: Jump starting
1. Start the engine of the booster vehicle and run the engine at
moderately increased speed.
2. Start the engine of the disabled vehicle.
3. Once the disabled vehicle has been started, run both engines for an
additional three minutes before disconnecting the jumper cables.
Connecting the jumper cables
Note: In the illustration, the vehicle on the bottom is used to designate the assisting (boosting) battery. 1. Connect the positive (+) jumper cable to the positive (+) terminal of the discharge ...Removing the jumper cables
Remove the jumper cables in the reverse order that they were connected. Note: In the illustration, the vehicle on the bottom is used to designate the assisting (boosting) battery. 1. Remove th ...See also:
Maintenance Safety
All service items not detailed in this
section should be performed by a
certified technician or other qualified
mechanic. ...
Unlocking and opening doors from the inside
Only open the door when the traffic situation permits.
If the vehicle was previously locked with the SmartKey or with KEYLESS-GO, opening
the vehicle from the inside will activate the antitheft ala ...
Windshield wiper service position
The windshield wipers must be in the service
position before the wiper blades can be
cleaned or replaced. See page 329 for additional
information. ...