Suzuki Grand Vitara: Improving Fuel Economy - Operating Your Vehicle - Suzuki Grand Vitara Owner's ManualSuzuki Grand Vitara: Improving Fuel Economy

The following instructions will help you improve fuel economy.

Avoid excessive idling

If you are to wait for more than a minute while you are parked, stop the engine and start it again later. When warming up a cold engine, allow the engine to idle until the temperature gauge pointer comes up to the “C” position. In this position, the engine is sufficiently warm for starting off.

Avoid “jackrabbit” starts

Fast starts away from lights or stop signs will consume fuel unnecessarily and shorten engine life. Start off slowly.

Avoid unnecessary stops

Avoid unnecessary deceleration and stopping. Try to maintain a slow, steady speed whenever possible. Slowing down and then accelerating again uses more fuel.

Keep a steady cruising speed

Keep as constant a speed as road and traffic conditions will permit.

Keep the air cleaner clean

Keep the air cleaner clean

A dirty air cleaner will cause the fuel injection system to supply too much fuel to the engine for the amount of air being supplied. The result is waste of fuel due to incomplete fuel burning.

Keep weight to a minimum

The heavier the load, the more fuel the vehicle consumes. Take out any luggage or cargo when it is not necessary.

Keep tire pressure correct

Underinflation of the tires can waste fuel due to increased running resistance of the tires. Keep your tires inflated to the correct pressure shown on the label located below the driver’s side door latch striker.

    Catalytic Converter
    Catalytic Converter The purpose of the catalytic converter is to minimize the amount of harmful pollutants in your vehicle’s exhaust. Use of leaded fuel in vehicles equipped with catalytic con ...

    Driving Tips
    WARNING: • Wear Your Seat Belts at All Times. Even though air bags are equipped at the front seating positions, the driver and all passengers should be properly restrained at all times, usi ...

    See also:

    Rear Wiper Blade Replacement
    The rear wiper blade and wiper arm have a cover for protection. The cover must be removed before the wiper blade can be replaced. To remove the cover: 1. Slide a plastic tool under the cover and ...

    Transfer case
    This section is only valid for vehicles with 4- wheel drive (4MATIC). Power is always transmitted to both axles. Performance tests may only be carried out on a 2-axle dynamometer. The brake sy ...

    Break-In
    CAUTION: The future performance and reliability of the engine depends on the care and restraint exercised during its early life. It is especially important to observe the following precautions dur ...