Volvo XC60: Ignition mode I
NOTE
To access ignition modes I or II without starting
the engine, the brake pedal must not be
depressed.
- With the remote key fully pressed into the ignition slot, press START/STOP ENGINE briefly.
Ignition mode 0
- Insert the remote key in the ignition slot and press it in as far as possible. ...Ignition mode II
- With the remote key fully pressed into the ignition slot, press START/STOP ENGINE for approximately 2 seconds. ...See also:
High/Low Beam Switch
Push the multifunction lever away from you to switch
the headlights to high beam. Pull the multifunction lever
toward you, to switch the headlights back to low beam. ...
Fog Lamps
The fog lamps control is located on the turn/lane change lever.
Use the fog lamps for better vision in foggy or misty conditions.
FOG (Fog Lamps): Turn the fog lamp
band on the lever to and re ...
Checking Engine Oil
It is a good idea to check the engine oil level at each fuel fill. In order to
get an accurate reading, the vehicle must be on level ground. The engine oil dipstick
handle is a yellow loop. See En ...