Hyundai Tucson: Higher speed motoring - Driving your Hyundai - Hyundai Tucson Owner's ManualHyundai Tucson: Higher speed motoring

Pre-Trip Inspections

1. Tires: Adjust the tire inflation pressures to specification. Low tire inflation pressures will result in overheating and possible failure of the tires. Avoid using worn or damaged tires which may result in reduced traction or tire failure.

NOTE: Never exceed the maximum tire inflation pressure shown on the tires.

WARNING: o Underinflated or overinflated tires can cause poor handling, loss of vehicle control, and sudden tire failure leading to accidents, injuries, and even death. Always check tires are properly inflated before driving. Refer to pages 2-28 and 8-3 for proper tire pressures and further information. o Driving on tires with no or insufficient tread is dangerous. Worn-out tires can result in loss of vehicle control, collisions, injury, and even death. Worn-out tires should be replaced as soon as possible and should never be used for driving. Always check tire tread before driving your car. Refer to 8-11 for further information and tread limits.

2. Fuel, engine coolant and engine oil: High speed travel consumes more fuel than urban motoring. Do not forget to check both engine coolant and engine oil. 3. Drive belt: A loose or damaged drive belt may result in overheating of the engine.

    Winter driving
    The more severe weather conditions of winter result in greater wear and other problems. To minimize the problems of winter driving, you should follow these suggestions: Snowy or Icy Conditions ...

    Use of lights
    Check your lights regularly for correct operation and always keep them clean. When driving during the day in conditions of poor visibility, it is helpful to drive with headlights on low beam. ...

    See also:

    DOOR position
    When the switch is in the DOOR position 2 the map lights will illuminate under the following conditions: - ignition switch is turned to the LOCK position — remain on for about 15 seconds. ...

    Braking
    Braking The distance needed to bring any vehicle to a halt increases with the speed of the vehicle. The braking distance needed, for example, at 60 km/h (37 mph) will be approximately 4 times gr ...

    Brake Adjustment
    Every time the brakes are applied, with or without the vehicle moving, the brakes adjust for wear. ...