GMC Terrain: Headlamps, Front Turn Signal, Sidemarker, and Parking Lamps
A. Low-Beam Headlamp
B. High-Beam Headlamp
C. Sidemarker Lamp
D. Park/Turn Signal Lamp
To replace one of these bulbs:
1. Turn the tire to reach the access port cap located in the front of wheel well cover.
A. Screw
B. Access Port Cap
2. Remove the screw (A) and turn the access port cap (B) counterclockwise to remove.
3. If replacing a headlamp bulb, remove the dust cover cap from the back of the headlamp housing by turning the cap counterclockwise.
4. Turn the bulb socket counterclockwise to remove it from the lamp assembly.
5. Remove the bulb from the socket or disconnect the bulb assembly from the harness
connector.
6. Install the new bulb.
7. Reinstall the bulb socket to the lamp assembly, turning clockwise.
8. Replace the dust cover cap on headlamps.
9. Reinstall the wheel well cover access port cap and secure by installing the screw.
Bulb Replacement
For the proper type of replacement bulbs, see Replacement Bulbs on page 10‑37.
For any bulb changing procedure not listed in this section, contact your dealer. ...
Fog Lamps
To replace one of these bulbs:
1. Locate the fog lamp assembly under the front facia.
2. Disconnect the bulb socket from the electrical connector, turn, and pull out
the bulb assembly.
3. Remov ...
See also:
Towing Equipment and Accessories
Towing can require a variety of
equipment, depending on the size of
your trailer, how it will be used, how
much load you are towing, and
where you tow.
Discuss your needs with your trailer
...
Shutting the Engine Off After a Remote Start
To shut off the engine:
○ Press until the parking lamps
turn off.
○ Turn on the hazard warning flashers.
○ Insert the key and turn it to ON/ RUN and then back to LOCK/OFF. ...
Introduction
System overview
1 Cell phone
2 Location of the microphone
3 Steering wheel keypad
4 Center console control panel and display ...
