Volvo XC60: Gate Operator/Canadian Programming
Canadian radio-frequency laws require transmitter signals to “time-out” (or quit) after several seconds of transmission – which may not be long enough for HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to “time-out” in the same manner.
If you live in Canada or you are having difficulties programming a gate operator or garage door opener by using the “Programming” procedures, replace “Programming HomeLink” step 2 with the following:
• Continue to press and hold the HomeLink button while you press and release - every two seconds (“cycle”) your handheld transmitter until the HomeLink indicator light changes from a slow to a rapidly blinking light. Now you may release both the HomeLink and hand-held transmitter buttons.
Proceed with “Programming” step 3 to complete.
Programming HomeLink
NOTE
Some vehicles may require the ignition
switch to be turned on or to the second
(“accessories”) position for programming
and/or operation of HomeLink. It is also recommended
that a ne ...
Using HomeLink
To operate, simply press and release the programmed
HomeLink button. Activation will
now occur for the trained device (i.e., garage
door opener, gate operator, security system,
entry door lock ...
See also:
Engine Cooling System Messages
A/C OFF DUE TO HIGH ENGINE TEMP
This message displays when the engine coolant becomes hotter than the normal
operating temperature. To avoid added strain on a hot engine, the air conditioning
com ...
Safety Belts
Refer to the following sections for important information on how to use safety
belts properly:
○ Safety Belts on page 3‑12.
○ How to Wear Safety Belts Properly on page 3‑ ...
Getting started
Use the controls on the steering wheel keypad
and in the center console to access, navigate
and make selections in the hands-free system’s
menus. ...
