Jeep Liberty: Front/Rear Axle Fluid
For normal service, periodic fluid level checks are not required. When the vehicle is serviced for other reasons the exterior surfaces of the axle assembly should be inspected. If gear oil leakage is suspected inspect the fluid level. Refer to “Fluids, Lubricants, and Genuine Parts” in “Maintaining Your Vehicle” for further information.
Fluid Level Check
• Front axle lubricant should be at the bottom edge of the oil fill hole when the vehicle is in a level position.
• Rear axle lubricant should be 0.5 in (11 mm) below the bottom edge of the oil fill hole when the vehicle is in a level position.
Adding Fluid
Add lubricant only at the fill hole and only to the level specified above.
Lubricant Selection
Use only manufacturer’s recommended lubricant. Refer to “Fluids, Lubricants, and Genuine Parts” in “Maintaining Your Vehicle” for further information.
Frequency Of Fluid Change
Under normal operating conditions, the lubricant installed at the factory will give satisfactory lubrication for the life of the vehicle. Lubricant changes are not necessary unless the lubricant becomes contaminated with water. Change the lubricant immediately if contaminated with water.
Frequency Of Fluid Change
Under normal operating conditions, the fluid installed at the factory will give satisfactory lubrication for the life of the vehicle. Fluid changes are not necessary unless the fluid becomes con ...Sky Slider™ Top Care
Immediate removal of any contaminant is recommended. Regular washing of the top will enhance its life and appearance, and make successive cleaning easier. Do not subject the top to excessive heat ...See also:
Notes on the Operator's Manual
This Operator's Manual contains a great deal of helpful information. We urge
you to read it carefully and familiarize yourself with the vehicle before driving.
For your own safety and longer se ...
Engine starting
Never start the engine, or
leave it
running, when the vehicle is in an
enclosed space. Exhaust gasses are
poisonous and can cause
unconsciousness and death if inhaled.
If the engine fails to ...
Using the Transfer Switch (if equipped)
Using the Transfer
Switch (if equipped)
Your vehicle is equipped with a four-mode full-time 4x4 system. You can use the
transfer switch to select any of the four modes: N, 4H, 4H LOCK, 4L LOCK.
...