Subaru Forester: Erasing HomeLink® button memory
NOTE
- Performing this procedure erases
the memory of all the preprogrammed
buttons simultaneously. The memory
of individual buttons cannot be erased.
- It is recommended that upon the sale of the vehicle, the memory of all programmed HomeLink® buttons be erased for security purposes.
1) HomeLink® button 1
2) HomeLink® button 2
3) HomeLink® button 3
1. Press and hold the two outer buttons (button 1 and button 3) until the indicator light begins to flash (after approximately 20 seconds).
2. Release both buttons.
Reprogramming a single HomeLink® button
1. Press and hold the HomeLink® button
you wish to reprogram. DO NOT release
the button until step 4 has been completed.
2. When the HomeLink® indicator light
begins to flash slowly (after ap ...
In case a problem occurs
If you cannot activate a device using the
corresponding HomeLink® button after
programming, contact HomeLink® at
www.homelink.com or call 1-800-355-
3515 for assistance. ...
See also:
Voice Command Tree
Refer to “Voice Tree” in this section. ...
Symbols in the instrument panel
WARNING
If and
come on at the same time
and the brake level is below the MIN mark
in the reservoir or if a brake system-related
message is shown in the information display: DO NOT DRIVE. ...
Recommended brake fluid
Refer to “Fluids”.
Never use different brands of brake
fluid together. Also, avoid mixing
DOT 3 and DOT 4 brake fluids even if
they are the same brand. ...
