Range Rover Evoque: Dynamic stability control (DSC)
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Stability control / Dynamic stability control (DSC)
DSC is automatically enabled each time the engine is started, and is automatically enabled by some of the Terrain response special programs.
The vehicle is not designed
for
cornering at the same speed as
conventional passenger cars any
more than a low-slung sports car is
designed to perform satisfactorily
under off-road conditions. If at all
possible, avoid sharp turns or abrupt
manoeuvres. As with other vehicles of
this type, failure to operate the
vehicle correctly may result in loss of
control or vehicle rollover.
READ NEXT:
Dsc warning lamp
The amber DSC warning lamp in
the instrument panel illuminates
briefly when the ignition is
switched on and extinguishes when the engine
is started.
If the lamp flashes while driving, the DSC
Disabling dsc
Safety may be reduced by
inappropriately disabling DSC. In the
majority of driving situations, and
particularly on-road, it is
recommended that you do not disable
DSC.
In some driving condition
Re-enabling dsc
DSC is re-enabled by one of the following:
- Press and briefly hold the DSC OFF switch.
- Stop and restart the engine.
- Select a new Terrain Response special
program.
SEE MORE:
Television
Module (TVM)
CAUTIONS:
Diagnosis by substitution from a donor vehicle is NOT acceptable.
Substitution of control modules does not
guarantee confirmation of a fault and may also cause additional faults in the
vehicle being checked and/or the donor
vehicle
When probing connectors to take measurements in th
Steering
Wheel Module
Steering Angle Sensor Module (SASM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle
NOTES:
I
© 2011-2024 Copyright www.rrevoque.org
