Range Rover Evoque: Drive selector
P should normally be selected before switching
off the engine. If any other gear is selected at
turn off, the selector will move to P before
retracting into the centre console.
If the engine is switched off with N selected, the
system will wait for 10 minutes before
selecting P. This time delay allows the vehicle
enough time to be conveyed through a car
wash. Do not use for vehicle recovery
purposes.
If your vehicles requires recovery by towing,
the recovery must be undertaken by qualified
personnel. See 216, RECOVERY.
READ NEXT:
If the drive selector is obstructed, remove the
obstruction and then start the engine. The
selector should elevate as normal.
If the selector still fails to elevate, even if there
is no obstructio
In the event that the transmission develops a
fault, a warning message may be displayed in
the message centre and only limited gears may
become available. You should seek qualified
assistance imme
Manual transmission
Selection of reverse gear is
prevented
when the vehicle is travelling in excess
of 24km/h (15mph). Never attempt to
engage reverse gear while the vehicle is
in forward mo
SEE MORE:
Special Tool(s)
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
204-727A
Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-807
Installer, Front Wheel Bearing
JLR-204-808
Installer, Front Wheel Bearing
General Equipment
Copper Hammer
Hydraulic press
Installation
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. NOTE: This step is only required if previously removed.
Torque: 12 Nm
2. NOTE: This step is only required if previously removed.
3. CAUTION: Make sure that the seal is correctly
© 2011-2024 Copyright www.rrevoque.org