Ford Escape: Compass zone adjustment
1. Determine which magnetic zone
you are in for your geographic
location by referring to the zone
map.
2. Turn ignition to the on position.
3. Start the engine.
4. Press the SETUP control to select the Update Zone function and display the current ZONE XX in the center stack display.
5. Continue to press the RESET control until the correct zone appears in the center stack display.
6. The direction will display after the RESET control is released. The zone is now updated.
Electronic compass (if equipped)
The compass heading is displayed in the center stack display. The compass reading may be affected when you drive near large buildings, bridges, power lines and powerful broadcast antenna. Magnetic ...Compass calibration adjustment
Perform compass calibration in an open area free from steel structures and high voltage lines. For optimum calibration, turn off all electrical accessories (heater/air conditioning, wipers, etc.) an ...See also:
Interior
Passenger compartment area
1) Lower anchorages for child restraint system
2) Seatbelt
3) Parking brake lever
4) Front seat
5) Rear seat
1) Center console
2) Cup holder
3) Front p ...
Towing Requirements – Tires
− Do not attempt to tow a trailer while using a compact
spare tire.
− Proper tire inflation pressures are essential to the safe
and satisfactory operation of your vehicle. Refer to
...
Roof loads
Using load carriers
Load carriers are available as Volvo accessories.
Observe the following points when in use:
• To avoid damaging your vehicle and to
achieve maximum safety when driving, we
...