Nissan Rogue: Choosing a language
You can interact with the Bluetooth® Hands- Free Phone System using English, Spanish or French.
To change the language, perform the following.
1. Push and hold the 
button for
more than
5 seconds.
2. The system announces: “Push the PHONE
SEND ( ) button for the hands-free
phone system to enter the speaker adaptation
mode or push the PHONE END (
)
button to select a different language.”
3. Push the button.
For information on speaker adaptation, see “Speaker Adaptation (SA) mode” later in this section.
4. The system announces the current language and gives you the option to change the language to Spanish (in Spanish) or French (in French). Use the following chart to select the language.
NOTE:
You must push the button or
the
button within 5 seconds to
change
the language.
5. If you decide not to change the language, do not push either button. After 5 seconds, the VR session will end, and the language will not be changed.
Getting started
The following procedures will help you get
started using the Bluetooth® Hands-Free Phone
System with NISSAN Voice Recognition. For
additional command options, refer to “List of
voice comman ...
Connecting procedure
NOTE:
The connecting procedure must be performed
when the vehicle is stationary. If
the vehicle starts moving during the procedure,
the procedure will be cancelled.
1. Push the button on t ...
See also:
Moving the vehicle
If the message Normal mode is displayed
when Safety mode See manual is no longer
displayed, the vehicle may be moved carefully
from its present position, if for example, it is
blocking traffic ...
When checking or servicing in the engine compartment (non-turbo models)
- Do not contact the belt cover
while checking the components
in the engine compartment.
Doing so may cause your hand
to slip off the belt cover and
result in an unexpected injury.
- D ...
Tire tread
WARNING
Although the applicable federal motor vehicle safety laws consider a tire to
be worn when the tread wear indicators (TWI) become visible at approximately 1/16
in (1.6 mm), we recomme ...
