Ford Escape: Check MyKey System Status
The vehicle’s message center system check will provide the status of the following MyKey parameters:
• MYKEY MILES — This odometer only tracks mileage when a MyKey
is used. If mileage does not accumulate as expected, then the MyKey
is not being used by the intended user. The only way to reset this
odometer to zero is by clearing MyKey . If this odometer is lower than
the last time you checked, then the MyKey system has been recently
cleared.
• # MYKEY(S) PROGRAMMED — Indicates how many MyKeys are
programmed to the vehicle. Can be used to detect deletion of a
MyKey .
• # ADMIN KEYS PROGRAMMED — Indicates how many Admin keys
are programmed to the vehicle. Can be used to detect if an additional
spare key has been programmed to the vehicle
Refer to Message center in the Instrument Cluster chapter for MyKey system warnings displays.
Clear MyKey
To reset all MyKeys as admin keys do the following: 1. Turn the vehicle on using the admin key. 2. Press SETUP until PRESS RESET TO CLEAR MYKEY is displayed. 3. Press and release the RESET button ...Using MyKey with Remote Start Systems
MyKey is not compatible with non-Ford approved aftermarket remote start systems. If you choose to install a remote start system please see your authorized dealer for a Ford approved remote start sys ...See also:
Tripped sensor identification
The security indicator light flashes when
the alarm system has been triggered.
Also, the number of flashes indicates the
location of unauthorized intrusion or the
severity of impact on the vehi ...
Power-Up
After switching the ignition key from OFF to either the
ON or ACC position, or after a language change, you
must wait at least fifteen seconds prior to using the
system.
...
Setting the compass
Determine your position using the following zone maps.
North America zone map
South America zone map
Press a round pin into opening 3() for approximately three seconds.
The currently ...