Volvo XC60: Changing the set speed
After a speed has been set, it can be increased or decreased by using the or buttons.
Each time one of these buttons is pressed, the vehicle's speed changes by 5 mph (approximately 8 km/h).
When the system is in active mode, the button has the same function as , but results in a smaller increase in speed.
NOTE
• If one of the Adaptive Cruise Control
buttons is pressed for more than
approximately one minute, ACC will be
deactivated. The engine must then be
switched off and restarted to reset ACC.
• In some situations Adaptive Cruise
Control cannot be put in active mode.
Cruise control Unavailable is shown
in the display, see page 162.
Setting a speed
Once ACC has been put in standby mode, use the or buttons to store (set) the vehicle's current speed. This puts the system in active mode. The set speed, for example 55 mph, is shown in th ...Setting a time interval
The set time interval to vehicles ahead can be increased by pressing and decreased by pressing . The current time interval is shown briefly in the display following adjustment. Different ...See also:
If your vehicle needs to be towed
If towing is necessary, we recommend having your vehicle towed by
your Toyota dealer or a commercial towing service, using a wheel-lift
type truck or a flat bed truck.
Use a safety chain system for ...
Redialing
The on-board computer saves the last names or numbers dialed in the redial memory.
Press the or
button on the steering wheel to
select the Tel menu.
Press the button to switch
to the ...
Set or increase cruise speed
When setting the cruise
control to the
speed limit, it is important to remember
that it is possible for the vehicle speed
to increase when travelling downhill.
This may result in the vehicle sp ...