Honda CR-V: CD Changer Error Messages (EX-L model with navigation system)

Honda CR-V (2006–2011) Owner's Manual / Features / CD Changer (EX-L model with navigation system) / CD Changer Error Messages (EX-L model with navigation system)

If you see an error message in the

If you see an error message in the display while playing a disc, find the cause in the chart to the right. If you cannot clear the error message, take your vehicle to your dealer.

The chart on the right explains the error messages you may see in the display while playing a disc.

If you see an error message in the display while playing a disc, press the eject button. After ejecting the disc, check it for damage or deformation. If there is no damage, insert the disc again.

For additional information on damaged discs.

Insert a different disc. If the new disc plays, there is a problem with the first disc. If the error message cycle repeats and you cannot clear it, take your vehicle to a dealer.

The audio systemwill try to play the disc. If there is still a problem, the error message will reappear. Press the eject button, and pull out the disc.

READ NEXT:

 Playing a PC card (EX-L model with navigation system)

Playing a PC card (EX-L model with navigation system)

 To Play a PC Card

You operate the PC card player with the same controls used for the radio and the disc player. To load or play a card, the ignition switch must be in the ACCESSORY (I) or ON (II) position. T

 Loading a PC Card

The PC card slot is behind the navigation screen. To use the PC card player, press the OPEN button beside the screen. The screen folds back, and the PC card slot appears. Insert a PC card

SEE MORE:

 DTC U0028: F-CAN Malfunction (BUS-OFF (PCM) )

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Check for Temporary DTCs or DTCs with the HDS. Is DTC U0028 indicated? YES-Update the PCM i

 DTC 86: F-CAN Communication

1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Turn the ignition switch OFF. 4. Start the engine. 5. Wait at least 5 seconds. 6. Check for DTCs with the HDS. Is DTC 86 indicated? YES-Go to step 7. NO-Intermittent failure, the system is OK at this time. Check for a loos

© 2016-2024 Copyright www.hcrv.net