Volvo XC60: Calibration - Compass - Your driving environment - Volvo XC60 Owner's ManualVolvo XC60: Calibration

The compass may need to be calibrated if, for example, the vehicle is driven into a new magnetic zone. The character C is shown in the mirror's display if calibration is necessary.

1. Stop the vehicle in a large open area, safely out of traffic and away from steel structures and high-tension electrical wires.

2. Start the vehicle.

NOTE
For best results from calibration, switch off all electrical equipment in the vehicle (climate system, windshield wipers, audio system, etc.) and make sure that all doors are closed.

3. Using a pen or similar object, press and hold the button on the underside of mirror until C is shown again in the mirror(after approx. 6 seconds).

4. Drive as usual. C disappears from the display when calibration is complete.

Alternative calibration method:

Drive slowly in a circle at a speed of no more than 5 mph (8 km/h) until C disappears from the display when calibration is complete.

    Operation
    Rearview mirror with compass. The rearview mirror has an integrated display that shows the compass direction in which the vehicle is pointing. Eight different directions are shown with the ab ...

    Selecting a magnetic zone
    Magnetic zones. The earth is divided into 15 magnetic zones. The correct zone must be selected for the compass to work correctly. 1. Put the ignition in mode II. 2. Using a pen or similar obje ...

    See also:

    A/C – Air conditioner button
    A/C – Air conditioner button If the windshield starts to fog when the climate control system is operated in the AUTO mode, press the air conditioner button “A/C” to defog and dehumidify ...

    Starting a disabled vehicle using a starting aid
    To start the vehicle using a starting aid or a slave battery, follow the instructions in the sequence given. 1. Connect the positive (Red) booster cable to the positive (+) battery terminal of the ...

    Select Another Mobile Phone
    This feature allows you to select and start using another phone paired with the Uconnect™ Phone. • Press the button to begin. • After the “Ready” prompt and the following beep, say ...