Subaru Forester: Audio set
Your SUBARU may be equipped with one of the following audio sets. Refer to the pages indicated in this section for operating details.
NOTE
If a cell phone is placed near the audio
set, it may cause the audio set to emit
noise when the phone receives calls.
This noise does not indicate an audio set malfunction. Note that a cell phone should be placed as far as possible from the audio set.
- Type A audio set (if equipped)
- Type B audio set (if equipped)
- Type C audio set (if equipped)
- Type D audio set (if equipped)
Installation of accessories
Always consult your SUBARU dealer
before installing a citizen band radio or
other transmitting device in your vehicle.
Such devices may cause the electronic
control system to malfunction if the ...
Type A audio set (if equipped)
Type A audio set (if equipped)
The audio set will operate only when the
ignition switch is in the “Acc” or “ON”
position.
- Power and audio controls: refer to page
- Radio operation: ...
See also:
Using the infotainment system
If the infotainment system is on when the ignition
is switched off, it will come on automatically
the next time the ignition is put in mode I
or higher and continue using the same source
(FM1, ...
If the EngineWon’t Start
Diagnosing why the engine won’t
start falls into two areas, depending
on what you hear when you turn the
ignition switch to the START (III)
position:
You hear nothing, or almost
nothing. ...
Opening and Closing the Hood
1. Park the vehicle, and set the
parking brake. Pull the hood
release handle located under the
lower left corner of the dashboard.
The hood will pop up slightly.
2. Reach in between the ho ...
