Volvo XC60: Active Bending Lights (ABL) - High/low beam headlights - Lighting - Your driving environment - Volvo XC60 Owner's ManualVolvo XC60: Active Bending Lights (ABL)

Headlight pattern with the Active Bending Light function deactivated (left)
Headlight pattern with the Active Bending Light function deactivated (left) and activated (right)

When this function is activated, the headlight beams adjust laterally to help light up a curve according to movements of the steering wheel (see the right-pointing beam in the illustration).

ABL is activated automatically when the engine is started.

The function can be deactivated/reactivated in the MY CAR menu system under My XC60 Active Bending Lights or under Settings Active Bending Lights or under Settings Car settings Car settings Light settings Light settings Active Active Bending Lights.

See page 133 for a description of the menu system.

NOTE
This function is only active in twilight or dark conditions, and only when the vehicle is in motion.

If a fault should occur in the system, the symbol will illuminate and a message will be displayed as shown in the table.

Parking lights

    Low beams
    When the engine is started, the low beams are activated automatically (daytime running lights) if the headlight control is in position 0 or . Daytime running lights can be deactivated in the ...

    Parking lights
    Headlight control in position for parking lights The parking lights (the license plate lights also come on) can be turned on even when the ignition is switched off. Turn the headlight control ...

    See also:

    Notes on the Operator's Manual
    This Operator's Manual contains a great deal of helpful information. We urge you to read it carefully and familiarize yourself with the vehicle before driving. For your own safety and longer se ...

    Gasoline containing alcohol and ethers, "Oxygenated fuels"
    Some fuel suppliers sell gasoline containing "oxygenates" which are usually alcohols or ethers. In some areas, state or local laws require that the service pump be marked indicating ...

    Setting the clock
    To set the time, press CLOCK. The display will read SET TIME. Use the memory preset numbers (0–9) to enter in the desired time–hours and minutes and press OK. The clock will then begin from that ...