Mitsubishi Outlander: Accessory socket
CAUTION:
● Be sure to use a “plug-in” type accessory operating at 12 V and at 120 W or less.
When using more than one socket at the same time, make sure that the electrical
accessories are 12 V accessories and that the total power consumption does not exceed
120 W.
● Long use of the electric appliance without running the engine may run down the
battery.
● When the accessory socket is not in use, be sure to close the lid or install the
cap, because the socket might become clogged by foreign material and be short-circuited.
To use a plug-in type accessory, open the lid or remove the cap, and insert the plug in the accessory socket.
NOTE:
● Accessory sockets in 3 locations can be used at the same time. However, make sure
that the total power consumption does not exceed 120 W.
The accessory socket can be used while the ignition switch is in either the “ON” or “ACC” position.
Vanity mirror
The vanity mirrors are located on the back of the sun visor. ...Interior lamps
1- Luggage room lamp 2- Room lamp (rear). 3- Map & room lamps (front). 4- Foot lamps* P. 8-58. NOTE: ● If you leave the lamps on without running the engine, you will run down the batt ...See also:
When connecting USB storage device
Repeating is operated in the same way a
CD is played. For details, refer to “Repeating”. ...
Registering by phone
1. Select the “BY PHONE” menu.
2. Select the “CONFIRM” menu. Then
“TRANSFER” is displayed.
3. Transfer the data from the cell phone.
For details about transferring the data,
refer t ...
High beam light bulbs
Right-hand side
1. Use a screwdriver to undo the clips on
the air intake duct, then remove the air
intake duct (right-hand side).
2. Disconnect the electrical connector
from the bulb.
3 ...