Jeep Liberty: Headlamp - Bulb Replacement - Maintaining Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Headlamp

1. Open the hood.

2. Reach behind the headlamp housing to access the headlamp bulb lock ring.

3. Firmly grasp the lock ring and rotate it counterclockwise to unlock it.

4. Remove the bulb and connector assembly from the headlamp housing.

5. Disconnect the bulb from the electrical connector and then connect the replacement bulb.

CAUTION!
Do not touch the new bulb with your fingers. Oil contamination will severely shorten bulb life. If the bulb comes in contact with any oily surface, clean the bulb with rubbing alcohol.

6. Install the bulb and connector assembly into the headlamp housing and rotate the lock ring clockwise to lock it in place.

7. Close the hood.

    Front Turn Signal And Front Side Marker Lamp
    1. Turn the steering wheel all the way to the right to access the left front turn signal or side marker. Turn the steering wheel all the way to the left to access the right front turn signal or ...

    See also:

    Electronically controlled 4WD system
    The electronically controlled 4WD system is an 4-wheel drive system that allows one of three drive modes to be selected with a switch, in accordance with the driving conditions. The following driv ...

    Heater operation
    Heating: This mode is used to direct heated air to the foot outlets. 1. Push the air recirculation button to the OFF position. (The indicator light turns off.) 2. Turn the air flow control ...

    Disc Player Error Messages (EX and EX-L models without navigation system)
    If you see an error message in the display while playing a disc, find the cause in the chart to the right. If you cannot clear the error message, take your vehicle to your dealer. The chart o ...