Jeep Liberty: Flash-To-Pass - Lights - Understanding The Features Of Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Flash-To-Pass

You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will turn on the high beam headlights until the lever is released.

NOTE: If the multifunction lever is held in the flash-topass position for more than 15 seconds, the high beams will shut off. If this occurs, wait 30 seconds before activating the flash-to-pass function again.

    High/Low Beam Switch
    Push the multifunction lever away from you to switch the headlights to high beam. Pull the multifunction lever toward you, to switch the headlights back to low beam. ...

    Instrument Panel Dimmer
    Rotate the center portion of the lever to the extreme bottom position to fully dim the instrument panel lights and prevent the interior lights from illuminating when a door is opened. Rotate th ...

    See also:

    Important safety notes
    In the following section, the term "sliding sunroof" refers to the panorama roof with power tilt/sliding panel. WARNING When opening or closing the sliding sunroof, make sure that t ...

    Changing the climate control air filter
    (For Evaporator and Blower Unit) (If Installed) The climate control air filter is located in front of the evaporator unit behind the glove box. It helps to decrease the amount of pollutants e ...

    Controls in the center console
    Controls in the center console 1 RADIO 2 MEDIA 3 TEL 4 TUNE 5 OK/MENU ...