Jeep Liberty: Engine Air Cleaner Filter - Maintenance Procedures - Maintaining Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Engine Air Cleaner Filter

Refer to the “Maintenance Schedule” for the proper maintenance intervals.

NOTE: Be sure to follow the “dusty or off-road conditions” maintenance interval if applicable.

WARNING!
The air induction system (air cleaner, hoses, etc.) can provide a measure of protection in the case of engine backfire. Do not remove the air induction system (air cleaner, hoses, etc.) unless such removal is necessary for repair or maintenance. Make sure that no one is near the engine compartment before starting the vehicle with the air induction system (air cleaner, hoses, etc.) removed. Failure to do so can result in serious personal injury.

Engine Air Cleaner Filter Selection

The quality of replacement engine air cleaner filters varies considerably. Only high quality filters should be used to assure most efficient service. MOPAR engine air cleaner filters are a high quality filter and are recommended.

    Engine Oil Filter
    The engine oil filter should be replaced with a new filter at every engine oil change. NOTE: For best access to the oil filter, a drive on hoist should be used instead of a chassis hoist (3.7L On ...

    Maintenance-Free Battery
    Your vehicle is equipped with a maintenance-free battery. You will never have to add water, nor is periodic maintenance required. WARNING! • Battery fluid is a corrosive acid solution and can ...

    See also:

    Voice Training
    For users experiencing difficulty with the system recognizing their voice commands or numbers, the Uconnect™ Phone Voice Training feature may be used. To enter this training mode, follow one o ...

    Used Replacement Wheels
    WARNING Replacing a wheel with a used one is dangerous. How it has been used or how far it has been driven may be unknown. It could fail suddenly and cause a crash. When replacing wheels, use a n ...

    Control panel for dual-zone automatic climate control
    To set the temperature, left () To set climate control to automatic () To switch climate control on/off () To switch the MONO function on/off14() To switch maximum cooling MAX COOL on/off ...