Jeep Liberty: Easy Entry/Exit Seat (Available With Memory Seat Only)
This feature provides automatic driver seat positioning to enhance driver mobility when entering and exiting the vehicle.
The distance the driver seat moves depends on where you have the driver seat positioned when you remove the key from the ignition switch.
• When you remove the key from the ignition switch, the driver seat will move about 2.4 in (60 mm) rearward if the driver’s seat position is greater than or equal to 2.7 in (68 mm) forward of the rear stop. The seat will return to its previously set position when you insert the key into the ignition switch and turn it out of the LOCK position.
• When you remove the key from the ignition switch, the driver seat will move to a position 0.3 in (8 mm) forward of the rear stop if the driver’s seat position is between 0.9 in and 2.7 in (23 mm and 68 mm) forward of the rear stop. The seat will return to its previously set position when you insert the key into the ignition switch and turn it out of the LOCK position.
• The Easy Entry/Easy Exit feature is disabled when the driver’s seat position is less than 0.9 in (23 mm) forward of the rear stop. At this position, there is no benefit to the driver by moving the seat for Easy Exit or Easy Entry.
Each stored memory setting will have an associated Easy Entry and Easy Exit position.
NOTE: The Easy Entry/Easy Exit feature can be turned on or off through the programmable features in the EVIC.
Refer to “Electronic Vehicle Information Center (EVIC)/ Customer-Programmable Features” in “Understanding Your Instrument Panel” for further information.
Memory Position Recall
NOTE:
• For vehicles equipped with an automatic transmission,
the vehicle must be in PARK to recall memory positions.
If a recall is attempted when the vehicle is not in
PARK, a message will ...
To Open And Close The Hood Lights
Two latches must be released to open the hood.
1. Pull the hood release lever located under the left side
of the instrument panel.
Hood Release
2. Outside of the vehicle, locate the safety latc ...
See also:
Locking the passengers’ windows
Locking the passengers’ windows
1) Lock
2) Unlock
Push the lock switch. When the lock
switch is in the “LOCK” position, the
passengers’ windows cannot be opened
or closed.
Push th ...
Windshield wiper blades
The wiper blades should be carefully inspected
from time to time and cleaned to remove accumulations
of road film or other debris. To clean
the wiper blades and arms, use a clean sponge
or c ...
Determining compatibility of tire and vehicle load capacities
The sum of four tires’ maximum
load ratings must exceed the maximum
loaded vehicle weight
(“GVWR”). In addition, sum of the
maximum load ratings of two front
tires and of two rear tire ...