Jeep Liberty: To Exit Remote Start Mode And Drive The Vehicle
Before the end of the 15-minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, insert the key into the ignition switch and turn the switch to the ON/RUN position.
NOTE: The ignition switch must be in the ON/RUN position in order to drive the vehicle.
To Exit Remote Start Mode Without Driving The Vehicle
Press and release the REMOTE START button one time or allow the engine to run for the entire 15-minute cycle. NOTE: To avoid unintentional shut downs, the system will disable the one-time press o ...Door Locks
...See also:
Other bulbs
There are bulbs other than the Xenon bulbs that you cannot replace. Replace only
the bulbs listed (). Have the bulbs that you cannot replace yourself changed
at a qualified specialist workshop.
M ...
Opening and closing the hood
1 Pull the lever located under the left side of
the dash to release the hood lock. An information
symbol will illuminate when the
hood is open.
2 Lift the hood slightly. Press the release
c ...
To Use The Engine Coolant Heater
1. Turn off the engine.
2. Open the hood and unwrap the electrical cord.
The electrical cord is located on the passenger side of the engine compartment,
in front of the air cleaner.
3. Plug it in ...