Range Rover Evoque: Connecting a device
Connecting a device
1. USB/iPod sockets.
2. 3.5 mm AUX socket.
3. Rear media USB/iPod socket.
4. Rear media AV sockets.
Connect the device into the appropriate socket.
Note: Use the cable supplied with your media device to connect to the USB socket.
When an iPod is connected, playback will continue from the point at which it was last playing, provided the iPod battery is in a good state of charge.
When a USB or Bluetooth® device is connected, playback will continue from the point it was last played. If a device is already connected when AUX is selected, playback will continue from the point at which it was last playing.
Please refer to the Ownership section of the Land Rover website at www.landrover.com, for a list of compatible devices.
Note: The Bluetooth® equipped devices listed
on Landrover.com, have been tested for
compatibility with Land Rover vehicles.
Performance will vary, based on the phone’s
software version and battery condition.
Devices are warranted by their manufacturer,
not Land Rover.
Do not plug non-audio
devices into the
USB port.
Note: A USB hub cannot be used to connect more than one USB device to the audio unit.
Note: Devices connected to the USB ports will be charged, but devices that are fully discharged will not play.
Note: Options such as Repeat and Mix relate to the device currently playing, they will not apply to any subsequent device.
READ NEXT:
Aux input socket
The 3.5mm AUX socket allows additional
equipment (e.g. personal stereos MP3 player,
hand-held navigation unit, etc.) to be
connected to the audio system.
The auxiliary power socket, situated next
Pairing and connecting a bluetooth® media device
For further information on Bluetooth® and
device compatibility, see 141, BLUETOOTH®
INFORMATION.
Using your media device
Note: The process of pairing and connecting
your media device with the v
Automatic reconnection
If devices have already been paired and
connected, when Bluetooth® is selected from
the My music menu, the system will
automatically connect to the last used device (a
confirmation pop-up appears
SEE MORE:
Power Steering FWD
Component Location
Steering gear
Rubber seal assembly
Heat shield
Overview
The vehicle is fitted with EPS (electric power steering), provided by a ZF
Servolectric steering gear unit with variable
ratio, rack and pinion steering and speed sensitive power assistance. Power
assistance is from a
Fender Apron Lower Panel
Removal
NOTES:
The fender apron lower panel is manufactured from mild steel.
The panel is serviced less its weld studs
This method describes the LH fender apron lower panel, the RH side is similar.
1. The fender apron lower panel is replaced in conjunction with:
Front bumper cover
Front bumper
