Jeep Liberty: Child-Protection Door Lock System — Rear Doors
To provide a safer environment for small children riding in the rear seats, the rear doors are equipped with a Child-Protection Door Lock system.
To use the system, open each rear door, use a flat blade screwdriver (or ignition key) and rotate the dial counterclockwise to engage the Child-Protection lock and clockwise to disengage the Child-Protection locks. When the system on a door is engaged, that door can only be opened by using the outside door handle even if the inside door lock is in the unlocked position.
Child-Protection Door Lock
NOTE:
• When the child lock system is engaged, the door can
be opened only by using the outside door handle even
though the inside door lock is in the unlocked position.
• After disengaging the Child-Protection Door Lock system, always test the door from the inside to make certain it is in the desired position.
• After engaging the Child-Protection Door Lock system, always test the door from the inside to make certain it is in the desired position.
• For emergency exit with the system engaged, move the lock knob up (unlocked position), roll down the window, and open the door with the outside door handle.
WARNING!
Avoid trapping anyone in a vehicle in a collision.
Remember that the rear doors can only be opened from the outside when the Child-Protection locks are engaged.
Automatic Unlock Doors On Exit Programming
The Automatic Unlock Doors On Exit feature can be
enabled or disabled as follows:
• For vehicles equipped with the Electronic Vehicle
Information Center (EVIC), refer to “Electronic Vehicle
...
Windows
...
See also:
Windshield Wiper/Washer
The windshield wiper/washer lever is located on the right side of the steering
column. With the ignition in ACC/ACCESSORY or ON/RUN/ START, move the windshield
wiper lever to select the wiper sp ...
Models without HID headlights
NOTE
This vehicle does not contain mercury
devices or parts. ...
Changing/disconnecting a device
- From the menu, select Change device.
- Select Disconnect. A confirmation pop-up
will appear and then you will be given the
option to Search new or select a different
device from the list of pair ...