Jeep Liberty: CD/DVD Disc Maintenance - Understanding Your Instrument Panel - Jeep Liberty Owner's ManualJeep Liberty: CD/DVD Disc Maintenance

To keep a CD/DVD in good condition, take the following precautions:

1. Handle the disc by its edge; avoid touching the surface.

2. If the disc is stained, clean the surface with a soft cloth, wiping from center to edge.

3. Do not apply paper or tape to the disc; avoid scratching the disc.

4. Do not use solvents such as benzene, thinner, cleaners, or anti-static sprays.

5. Store the disc in its case after playing.

6. Do not expose the disc to direct sunlight.

7. Do not store the disc where temperatures may become too high.

NOTE: If you experience difficulty in playing a particular disc, it may be damaged (i.e., scratched, reflective coating removed, a hair, moisture or dew on the disc) oversized, or have protection encoding. Try a known good disc before considering disc player service.

    CD Player
    Pressing the top of the switch once will go to the next track on the CD. Pressing the bottom of the switch once will go to the beginning of the current track, or to the beginning of the previous ...

    Radio Operation And Mobile Phones
    Under certain conditions, the mobile phone being on in your vehicle can cause erratic or noisy performance from your radio. This condition may be lessened or eliminated by relocating the mobile ...

    See also:

    Lower Anchors and Tethers for Children (LATCH System)
    The LATCH system holds a child restraint during driving or in a crash. This system is designed to make installation of a child restraint easier. The LATCH system uses anchors in the vehicle and at ...

    Ventilation
    Ventilation To force outside air through the instrument panel outlets: 1. Set the air inlet selection button to the OFF position. 2. Set the airflow control dial to the “” position. ...

    Resetting the side windows
    You must reset each side window if a side window can no longer be closed fully. Close all the doors. Turn the SmartKey to position 1 or 2 in the ignition lock. Pull the corresponding switch on ...