Range Rover Evoque: Attaching tether straps
1. Install the child restraint securely in one of
the rear seating positions.
2. Pass the tether strap over the seat back and
beneath the head restraint.
3. Attach the tether strap hook to the tether
anchor point on the back of the seat.
Ensure that the tether strap hook is facing
the correct way.
4. Tighten the tether strap according to the
manufacturer's instructions.
READ NEXT:
Airbag supplementary restraint system (SRS)
1. Front passenger’s airbag
2. Curtain airbags
3. Side airbags
4. Knee-bolster airbag
5. Driver’s airbag
Note: The general location of airbags f
For the airbags to operate
correctly
the roof lining and door post trims
must be in good condition, correctly
fitted, and free from obstruction. Any
damage, wear, or incorrect fitment
should b
Crash test data and
statistics show
that the safest place for a child to be
restrained is in a child seat correctly
fitted to the vehicle's rear seat.
Do not use a child restraint on a seat
pr
SEE MORE:
Removal
NOTES:
The inner quarter panel and wheelhouse is manufactured from mild steel.
The aid of a second technician is required to remove, offer up and align the
inner quarter panel and wheelhouse.
The service panel is not fully welded.
1. In this procedure, to make sure the vehicle is correctl
Special Tool(s)
100-012
Slide Hammer
205-872
Installer, Transfer Case Seal
308-615
Remover, Seals
308-617
Depth Drill, Seal Remover
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
alway
© 2011-2024 Copyright www.rrevoque.org