Honda CR-V: Adjust the Seat-Backs
Adjust the driver’s seat-back to a comfortable, upright position, leaving ample space between your chest and the airbag cover in the center of the steering wheel.
Passengers with adjustable seatbacks should also adjust their seatback to a comfortable, upright position.
Reclining the seat-back too far can result in serious injury or death in a crash.
Adjust the seat-back to an upright position, and sit well back in the seat.
Reclining a seat-back so that the shoulder part of the belt no longer rests against the occupant’s chest reduces the protective capability of the belt. It also increases the chance of sliding under the belt in a crash and being seriously injured. The farther a seat-back is reclined, the greater the risk of injury.
See page for how to adjust the manual adjustable seat-back, and page for the power adjustable seat-back.
READ NEXT:
Adjust the Head Restraints
Adjust the driver’s head restraint so
the center of the back of your head
rests against the center of the
restraint.
Have passengers adjust their head
restraints properly as well. Talle
Fasten and Position the Seat Belts
Insert the latch plate into the buckle,
then tug on the belt to make sure the
belt is securely latched. Check that
the belt is not twisted, because a
twisted belt can cause serious
injuries
Maintain a Proper Sitting Position
After all occupants have adjusted
their seats and head restraints, and
put on their seat belts, it is very
important that they continue to sit
upright, well back in their seats, with
their f
SEE MORE:
Driver's Airbag Replacement
Removal
1. Disconnect the negative cable from the battery and
wait at least 3 minutes before beginning work.
2. Remove the access panel (A) from the steering
wheel, then disconnect the driver's airbag 4P
connector (B) and horn switch 1P connector (C)
from the cable reel.
3. Using a TORX T30 bit, r
Front Bumper
Front Bumper Removal/Installation
NOTE:
Have an assistant help you when removing and
installing the front bumper.
Take care not to scratch the front bumper and body.
Put on gloves to protect your hands.
1. Remove the front bulkhead cover.
2. Remove the bolts (A) and clips (B, C) securing the
