Jeep Liberty: Adding Fluid - Transfer Case - Maintenance Procedures - Maintaining Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Adding Fluid

Fluid should be added only to fill hole until fluid begins to run out of the hole.

    Fluid Level Check
    The fluid level should be to the bottom edge of the fill hole (1) when the vehicle is in a level position. 1 — Fill Plug 2 — Drain Plug ...

    Draining Fluid
    First remove the fill plug (1), then the drain plug (2). Recommended tightening torque for the drain and fill plugs is 15–25 ft lbs (20–34 N·m). CAUTION! Do not over-tighten the plugs. You ...

    See also:

    Resetting the side windows
    You must reset each side window if a side window can no longer be closed fully. Close all the doors. Turn the SmartKey to position 1 or 2 in the ignition lock. Pull the corresponding switch on ...

    Fuel system
    Under no circumstances should any part of the fuel system be dismantled or replaced by anyone other than a suitably qualified vehicle technician. Ensure sparks and naked lights are kept away f ...

    Door open warning light
    The door open warning light illuminates if any door or the rear gate is not fully closed. Always make sure this light is out before you start to drive. ...