Mercedes-Benz GLK-Class: Releasing seat belts
- Press release button 4() and guide belt tongue 2 back towards belt sash guide 1.
Make sure that the seat belt is fully rolled up. Otherwise, the seat belt or belt tongue will be trapped in the door or in the seat mechanism. This could damage the door, the door trim panel and the seat belt. Damaged seat belts can no longer fulfill their protective function and must be replaced. Consult an authorized Mercedes- Benz Center.
Using the rear center seat belt
If the left-hand rear seat backrest is folded down and back up again, the rear center seat belt may lock. The seat belt can then not be pulled out. To release the rear center seat belt: pull out ...Belt warning for the driver and front passenger
Regardless of whether the driver and front passenger have fastened their seat belts already, the seat belt warning lamp lights up for 6 seconds after every engine start. It then goes out if the d ...See also:
Overview of interior lighting
Switches the rear interior
lighting on/off
Switches the automatic interior
lighting control on/off
Switches the right-hand front
reading lamp on/off
Switches the front interior ...
Front Seat Heater (if equipped)
Front Seat Heater
(if equipped)
With the ignition switch in the “ON” position, push in one or both of the seat
heater switches to warm the corresponding seat(s). The indicator light below th ...
Seat belt inspection
● Check the belts for cuts, worn or frayed webbing and for cracked or deformed metallic
parts. Replace the belt assembly if defective.
● A dirty belt should be cleaned with neutral d ...