Volvo XC60: Using City Safety
NOTE
The City Safetyâ„¢ function is activated automatically
each time the engine has been
switched off and restarted.
On and Off
In certain situations, it may be desirable to switch City Safetyâ„¢ off, such as when driving in close quarters where leaves, branches, etc.
may obscure the hood and windshield.
When the engine is running, City Safetyâ„¢ can be switched off as follows:
Press My Car in the center console control panel and go to Settings Car settings Driver support systems City Safety.
Select Off.
If the engine is switched off, City Safetyâ„¢ will reactivate when the engine is restarted.
WARNING
The laser sensor emits light when the ignition
is in mode II or higher, even if City
Safetyâ„¢ has been switched off.
To switch City Safetyâ„¢ on again:
• Follow the same procedure as for switching City Safety™ off but select ON.
Function
Location of the laser sensor in the windshield City Safetyâ„¢ monitors traffic ahead of you using a laser sensor mounted in the upper section of the windshield. If a collision is imminent, Ci ...Limitations
The sensor used by City Safetyâ„¢ is designed to detect cars and other larger motor vehicles ahead of your vehicle in both daylight and darkness. However, there are certain limitations and the ...See also:
Driving on Hills
Driving safely on hills requires good judgment and an understanding of what the
vehicle can and cannot do.
WARNING
Many hills are simply too steep for any vehicle. Driving up hills can cause the
...
What to do if...
■Warning lights
Brake system warning
light
Charging system warning
light
Low engine oil pressure
warning light
Malfunction indicator
lamp
SRS warning light
Open door warning ...
Center Table
On LX and EX models
To use the center table, pull up the
outside edge of the table until it
latches. To store it, pull the lever and
lower the table.
Sitting on or getting under the ta ...