Range Rover Evoque: Tyre change
Valve stem seal, washer, nut,
valve core
and cap should be replaced at every tyre
change. Valve stem seal, washer and
nut must be replaced if valve retention
nut is loosened. Sensor units and nuts
must be refitted using correct torque
figures and associated profile. Damage
to the vehicle may result if these
precautions are not taken.
Any tyre changes must be carried out by a
qualified technician. Great care must be taken
during removal and refitting of tyres to avoid
damaging the sensor.
READ NEXT:
Should the sensor require replacing, it should
be carried out by a Dealer/Authorised Repairer.
A replacement sensor must be fitted to a
running wheel in order to be recognised by the
system. The v
If you are in any doubt
regarding your
ability to carry out the instructions,
contact your Dealer/Approved
Repairer before attempting the repair.
Your vehicle may not be equipped with a spare
SEE MORE:
Removal
NOTES:
The rocker panel inner reinforcement is manufactured from boron steel.
The rocker panel inner reinforcement is unpicked from the side panel
reinforcement 'ring-frame', it is not serviced separately.
In this procedure the b-pillar reinforcement will be fitted in combination with
th
Remove any heavy deposits of
mud and
dirt with a hose before washing the
vehicle.
Never aim a hose water jet directly at
the engine air intake, heater air intakes,
body seals or at any components which
may be damaged.
Do not use a high pressure washer or
steam cleaner in the engine
compa
© 2011-2024 Copyright www.rrevoque.org